Teach you some frosted glass installation notes! Now when we talk about distance door, we will mainly think of office glass distance, not only because it looks beautiful, but also because it is very useful, frosted glass installation partition need to pay attention to what?

Can increase a sense of visual enlargement of the space, and it is also a cost-effective choice. So, office glass distance should be in equipment when what to pay attention to? Today's office glass distance to say it!

The main thing to know office glass distance equipment when highly decorated office glass distance to use the choice of 12 mm toughened glass to do, in people's parallel vision to do carved or grinding, office glass distance is generally 1.8 meters or 2 meters can be. Because of the clear water of the general house in the 2.7 meters, after doing the ceiling, the general height of 2.4 meters, because too high lighting is not good enough, so the general distance to moderate, do not exceed 2 meters. Choose commonly used thickness can be 10 mm, the surface for custom art patterns decoration, with distance hardware fittings fixed to the floor and wall, the main components are: glass door fan, neutral plate, side plate, pull rod, foot Sheetfoot, door lock, hinge, etc. From production to equipment sequence: ordering, cutting, opening, carving, packaging, transportation, equipment.

The glass distance door in the equipment office should be noted:

1.Glass and the base stainless steel frame of the bond can not be too close, glass into the stainless steel frame, the top and side of the stainless steel frame should be left about 3 mm gap, the gap is prepared for the glass thermal expansion cold contraction.

2.equipment office glass distance before, to see whether the corner of the glass is square, to see whether the standard of stainless steel frame is correct, whether the phenomenon of walking. In the corrected stainless steel frame, set the azimuth of the glass equipment, and fix the glass plate against the line.

3.in the equipment office glass distance, the glass sucker machine with thick glass suction, and then holding the sucker by 2-3 people will thick glass plate up, move to the equipment position. Then the upper part of the glass was inserted into the limit slot at the top of the door frame, and the lower part of the glass was placed on the bottom support. The lower part of the glass was aligned with the center line, and the two sides of the glass just sealed the metal decoration at the door frame to face the seam, request to do inside and outside can not see the facing interface.

4.When filling sealant into the gap between the top limit slot and the bottom bracket slot, as well as the gap between the thick glass and the frame column, when filling the sealant into the glass seal, from the end of the gap where glue is needed, the glass glue is poured evenly along the gap to form a straight line on the surface, scrape the remaining glass glue with a plastic sheet, and wipe the glue mark with a cloth.

5.Glass Butt, glass door fixed part because of the standard is too large and the need for splicing glass, the joint to have 2-3 mm width, glass plate edge to chamfer treatment. After the glass is fixed, the glass glue is injected into the joint gap. After filling with plastic sheets on both sides of the glass plate on the seam will glue scrape flat, so that the gap to form a clean uniform straight line, clean cloth on the glass wipe clean glue.